This guide will show you how to assemble the tablet case, tablet mount, and power strip of an Attendant® Vital Signs Monitors (VSM).
We have pre-assembled several components of the mounting kit for you. You will need a medium Philips-head screwdriver and hex key (included) for assembly. Alternatively, you can use a power screwdriver/drill set. Lock the wheels on the bottom of the VSM stand prior to assembly.
1. Hand thread the screws into the second set of pre-threaded mounting holes below the top plate. Do not screw all the way in; leave a gap of approximately ½” between the screwhead and the pole of the stand. |
|
|
2. Hook the tablet mounting bracket over the |
|
|
3. Mount power strip and cord wrap on alternate sides of the stand by tightening screws with the provided hex key through the power strip and cord wrap into the pre-threaded holes. |
|
|
4. Wrap the power cord around the cord wrap. |
||
5. Open the tablet holder by squeezing the two handles at its base. |
|
|
6. Place the tablet into the tablet holder, and press down on the top of the tablet holder to lock the tablet into place. |
|
|
7. Plug the USB cable into the port on the bottom of the tablet. |
|
|
8. Thread the vital signs monitor power cord and tablet USB cable through the stand, pulling them out the hole in the bottom of the pole. Plug the vital signs monitor power cord into the power strip. Connect the tablet USB cable to the charging brick, and plug it into the power strip. Note: do not thread the blood pressure hose or SpO2 cables through the pole. |
|