This guide will show you how to assemble your Welch Allyn® Vital Signs Monitors (VSM).
We have pre-assembled several components for you. You will need a medium Philips-head screwdriver and hex key (included) for assembly. Alternatively, you can use a power screwdriver/drill set. Lock the wheels on the bottom of the VSM stand prior to assembly.
1. Prepare monitor for removal from stand. Disconnect all peripheral devices from the Welch Allyn VSM. Use a Philips-head screwdriver to remove the four screws on the back of the rolling-stand mount. | ![]() |
2. Remove the monitor from the stand. Once screws are removed, lift the Welch Allyn VSM off the rolling-stand mount and set aside. |
|
3. Place the DS smart® mounting plate with the attached tablet on the Welch Allyn stand mounting pegs. Stabilize the DS smart mounting plate with the attached tablet until it is secured in Step 4. |
|
4. Replace the Welch Allyn VSM on the mounting pegs over the DS smart mounting plate with the attached tablet. Use the four Philips-head screws included to reattach the Welch Allyn VSM to the rolling-stand mount with the DS smart mounting plate with the attached tablet between the two. | ![]() |
5. Attach the power strip to the stem of the rolling stand by tightening the screw clamps. | ![]() |
6. Plug the tablet charger into the power supply and feed the other end of the cable through the tablet case to prevent theft. To open the tablet case, use the lever behind the bottom of the screen. | ![]() |
7. Secure the tablet-charging cable by pushing down on the top and bottom of the case to close it. Be sure to plug the cable into the tablet with enough slack so as to not strain the cable at point of connection. | ![]() |